Manual Flash Nikon Sb-22

E Foreword Speedlight parts Preparation TTL Auto Flash t Mode Checking the Correct Exposure Non-TTL Auto Flash ˙ Mode Autofocus Flash Operation in Dim Light 1 Set the SB-22s’s POWER switch to OFF, then slide down the battery chamber lid in the direction of the arrow and lift it off. 2 Install four penlight batteries following the + and symbols inside the chamber. Reattach the battery chamber lid by aligning the indices on the lid and flash unit and sliding it up as far as it will go. Four penlight batteries of any of the following types may be used: AA-type zinc-carbon AA-type alkaline-manganese AA-type NiCd (rechargeable) AA-type Ni-MH (Nickel-Metal Hydride) (rechargeable) AA-type (1.5V) lithium For more information on batteries, refer to “Notes on Batteries.” CAUTION When replacing batteries, replace all four batteries at the same time, do not mix battery types or brands, do not use old with new batteries, and never reverse the polarity of the batteries when installing.

Otherwise, the batteries may catch on fire or explode, due to the possible leakage of corrosive liquids. In the event that corrosive liquids do seep from the batteries, avoid touching the liquids. Certain types of batteries contain strong alkaline liquids. If the alkaline liquids stick to your skin or clothes, wash immediately with running water. 3 Loosen the SB-22s’s mounting foot lock nut.

The old SB-22 claims a manual Guide Number of 82. These are about one stop less than Nikon specifies, which is typical for flash makers.

Xfb File Transfer Mechanism. Slide the SB-22s into the camera’s accessory shoe and tighten the lock nut. 4 Set the SB-22s’s POWER switch to ON or STBY (standby) position. If both the SB-22s and camera are not used for after approx.

80 seconds, the SB-22s shuts off automatically and the ready-light goes out to conserve battery power. This is called the standby function. To turn the SB-22s on again after it enters the standby mode, you can lightly press the shutter release button or press the FLASH button once. NOTE Do not use the standby function: If the SB-22s is mounted on Nikon F3-series, New FM2, FM10 or FE10 cameras. If the SB-22s is mounted on Nikon FA or FE2 cameras and the shutter speed is set to M250 or B (bulb). If the SB-22s is mounted on Nikon FG or Nikonos V cameras and the shutter speed is set to M90 or B (bulb). If the SB-22s is mounted on a Nikonos V with an optional sync cord for land use connected and the shutter speed is set to M90 or B (bulb).